AirPop Masks

All AirPop masks are latex-free, all materials that your face can and will be in contact with are skin-friendly (ISO 10993-5 2009-10, tested by the Hohenstein Institute).

All adult masks can be worn for 40 hours which, if used correctly, results in far less waste than masks that are made for one-time use or that should be changed after 4 - 5 hours.

No, AirPop masks are not NIOSH N95 certified at this stage. The masks are manufactured in the same factories as one of the leading N95 approved manufacturers and we adhere to the same rigorous material performance and quality controls as N95 masks.

AirPop masks exceed international mask material performance standards and European Community Barrier mask requirements in addition to being certified respirators in Asia.

The Light SE & Kids masks can be washed in a washing machine for up to 5 - 10 wash cycles, at 30 - 40 degrees Celsius with water only. Please note that masks will have a reduced filtration of 70%. To keep 99.3% particle filtration (PFE) and 99.9% bacterial filtration (BFE), you can wear our mask for up to 40 hours and after that, they have to be thrown away. The masks can be disinfected with a 70%+ alcohol solution from the inside and outside but still need to be thrown away after 40 hours.

No, the Light SE and Kids masks do not require an additional filter.

Up to this point, the CAA does not have special requirements for consumer masks. Actually, there are nearly no requirements for consumer masks in general, other than requiring one to be used when on flights. Different airlines decide on their own regulations at this point but that could be subject to change.

Unfortunately, the Kids masks are too big for children under the age of 3 years old. They will suit a child from approximately 3 years old until 12 years old.

AirPop products do not feature a nose wire in terms of a bendable element. However, all AirPop masks are equipped with a nose seal, the Light SE Mask for instance features a flexible silicone nose bridge seal that forms the contours of the wearer's face. This silicone nose bridge seal ensures the mask to seal off any gaps that could occur around the nose-bridge to prevent leakage and also makes wearing this mask super comfortable! Besides all of this, the seal created around the nose bridge, when properly fitted, can help reduce fogging.

You can wear the mask for up to 40 hours and after that, they have to be thrown away. The masks can be disinfected with a 70%+ alcohol solution from the inside and outside but still need to be thrown away after 40 hours.

When purchasing an AirPop product, all filters and disposable masks are packed in resealable bags to store the masks before they are being used. When using a mask, we recommend to store them in a well-ventilated area so that the masks stay clean and fresh! Please follow the instruction for use online and clean as advised between uses to keep you mask hygienic.

The materials used in Airpop masks have been tested to filter 99.9% of bacteria, 99.3% of particles, and the outer layer is 100% fluid resistant. This means they minimize the projection of your respiratory droplets into the environment and also provide you with the most effective barrier against respiratory droplets from others around you.

Unfortunately, at this time AirPop products are recyclable, so the masks should be thrown out in general waste. However, AirPop try to produce their products and packaging as eco-friendly as possible and care deeply about sustainability. Bear in mind that upon throwing out the mask it might contain contagious material such as bacteria or a virus, so we recommend to put the mask in some sort of cover (paper / plastic bag) to make sure this material cannot be transmitted by any leakage or accidental touching of the product. Another option would be to disinfect the interior and exterior of the mask with a 70%+ alcohol solution before disposing of it.

AirPop masks and filters are built with 4 layers that block bacteria, dust & particulates with electrostatically charged. The unique outer layer protects, with the inner layer providing a skin-friendly and hypoallergenic environment. The masks have 4 layers but the electrostatically charged melt-blown layer is a “dual thickness” layer.

AirPop masks are originally a Chinese brand, and also produced in China. You can find out more about AirPop via this link: www.airpophealth.com/about